11 steps · 3 traps · 14mm / 17mm drain plug, crush washer & 0W-20 / 5W-30 spec reference
✓ Verified Tool & Torque Specs · Generic 3D Layout
A generic car’s engine oil and filter changed in 3D, the way the job really goes: warmed, chocked and lifted onto two axle stands, the sump’s drain plug told apart from the gearbox’s and the oil drained, the old filter off with its seal checked, the new one oiled and spun on hand tight plus a three-quarter turn, the plug back with a new crush washer to its torque, the car down level, filled to the dipstick’s mark, run and checked for leaks. Press play to watch a step, Explode to spread the sump and the filter, Reassemble for the order it goes back together.
A generic five-door car in the bay on firm, level concrete, with the bay door open. The kit: engine oil of the grade and specification its handbook gives (here 4.2 litres, 4.4 US quarts, of 5W-30 full synthetic), a new oil filter and a new crush washer for the drain plug, a 3/8-inch ratchet with a 17 mm socket, a torque wrench, an oil filter wrench, a drain pan bigger than the sump, a funnel, a trolley jack, a pair of axle stands rated for the car, two wheel chocks, a torch, rags and gloves.
Tools: 3/8-inch ratchet, 17 mm socket, Torque wrench, 10–60 Nm, Oil filter wrench, Drain pan and funnel, Trolley jack, two axle stands, chocks