9 steps · 4 screws · 2 connectors · 9 V for 90 seconds
An iPhone 16 taken apart in 3D the way Apple’s manual and iFixit open it for a new battery: from the back. Two P2 screws, heat, a suction cup and two picks kept to 3 mm, the back glass swung open to the right on its cable, the battery unplugged before the coil cable, and then what is new on the iPhone 16: no pull tabs, but an adhesive that lets go when a 9 V battery is clipped across it for 90 seconds. Press play to watch a step, Explode to spread the layers, Reassemble to fit the new battery and close the phone.
An iPhone 16. Its battery comes out from the back, as the iPhone 15’s does, but it is no longer held down by pull tabs: its adhesive lets go when a small voltage is put across it. Tools: a P2 pentalobe and a Y000 tri-point driver (Apple uses torque drivers set to 0.65 and 0.45 kgf·cm), a heat pad, a suction cup, two thin plastic picks, a nylon spudger, blunt ESD-safe tweezers, a block of foam as high as the phone, and a 9 V battery with a snap connector whose two leads end in alligator clips. Keep a tub of dry sand within reach, as Apple’s manual does, and run the battery right down before you start.
Tools: P2 pentalobe torque driver, Y000 tri-point torque driver, Heat pad, Suction cup lifter, Two plastic opening picks, Nylon spudger, ESD-safe tweezers, Foam block, 9 V battery and clip leads