7 steps · 15 screws in five lengths · M.2 2230 SSD · 1 ZIF flex
A Steam Deck LCD taken apart in 3D for its two most common jobs: a bigger M.2 2230 SSD and a new right thumbstick. First the microSD card, then the eight back screws in two lengths, the cover’s clips, the foil tape and the board shield, the battery’s pull tab, the SSD and its foil sleeve, and the stick’s ZIF flex. Press play to watch a step, Explode to spread the layers, Reassemble to fit the new parts and close it up.
A Steam Deck LCD, its battery run down below 25% and put in battery storage mode from its BIOS, lies face down on an ESD foam cradle with a pocket for each stick. Tools: a Phillips #1 driver for the back cover, a Phillips #0 for the screws inside, a plastic opening pick, a nylon spudger and ESD tweezers. The new single-sided M.2 2230 SSD waits on its anti-static bag, the new right thumbstick in a foam stand.
Tools: Phillips #1 screwdriver, Phillips #0 screwdriver, Plastic opening pick, Nylon spudger, ESD tweezers