7 steps · T30 + 8 mm · 2017–2023 Model 3 & 2020–2024 Model Y front door · 3 traps to avoid
A 2017–2023 Tesla Model 3’s driver’s door taken apart in 3D the way Tesla’s own procedures do it (the 2020–2024 Model Y’s goes the same way): the quiet speaker found first, the tweeter lifted out and unplugged, the puddle light levered out and unplugged before the panel moves, the reflector and armrest cover off, three T30 bolts out, the clips freed from the bottom up, the release cable unhooked, and the woofer’s plug checked before the woofer is blamed. Press play to watch a step, Explode to spread the door’s layers, Reassemble for the way it goes back.
A 2017–2023 Tesla Model 3’s driver’s door, open wide in the bay; the 2020–2024 Model Y’s front door comes apart the same way in Tesla’s manuals. The trim panel carries the tweeter in its top front corner, the puddle light underneath and the reflector on its rear edge, and three T30 bolts hold it to the door; behind it the woofer is bolted low at the front. You need a T30 Torx driver or socket, an 8 mm socket, a plastic trim tool, a small flathead screwdriver and a soft blanket to lay the panel on. Buy a woofer only once steps 1 and 7 say it is the woofer.
Tools: T30 Torx driver or socket, 8 mm socket, Plastic trim tool, Small flathead screwdriver