10 steps · 7 screws · 8 motor wires · 14 solder joints a stick
An Xbox Series X|S controller taken apart in 3D to fit a new LB/RB bumper bar and replace a drifting stick: the grip panels, the five TR8 screws and the one hidden under the bay label, the top case, the top cap and the bumper bar, the mid-frame, the antennas, the eight motor wires, the mainboard and the stick module’s 14 solder joints. Press play to watch a step, Explode to spread the layers, Reassemble to put it back together.
An Xbox Wireless Controller for Series X|S (model 1914), switched off, lies face down on an ESD mat. Tools: a TR8 security Torx driver (a T8 bit with a hole for the pin in each screw, sold as T8H), a T6 Torx driver, a nylon spudger and ESD tweezers; for the stick, a soldering iron with flux and desoldering wick or a pump, a PCB holder and a foam block. The bumper fix needs no soldering.
Tools: TR8 security Torx driver, T6 Torx driver, Nylon spudger, ESD tweezers, Soldering iron