8 steps · 2 traps to avoid · Bosch 24-inch built-in · E:24 and E:25
A Bosch dishwasher that leaves water in the tub, or stops with E:24 or E:25, is usually blocked somewhere in its drain long before its pump is worn out: BSH’s own bulletin names debris in the drain system as the most likely cause and says many drain pumps are replaced unnecessarily. See the whole drain in 3D before you open it: the three filters, the grey pump cover that has to click back in, the impeller, the house side with its high loop, then the check valve and the drain pump.
On Bosch’s 24-inch built-in dishwashers of the 2015–2022 platform (BSH’s repair manual calls it GV640), waste water leaves through three filters in the tub floor, then past a drain pump cover in the sump, through the drain pump under it, a check valve in the sump’s outlet and the drain hose with its high loop. Steps 1 to 5 are the owner’s clean-out from Bosch’s own manuals; steps 6 to 8 are the repair manual’s technician work at the base.
Tools: Spoon, Needle-nose pliers, Bit driver: #2 Phillips and T20 Torx, Small flat-blade screwdriver, Multimeter