7 steps · 2 traps to avoid · KitchenAid’s service order · Artisan KSM150 and other tilt-heads
When a KitchenAid tilt-head mixer hums but its beater stays still, the fibre worm gear in the head is the usual suspect. Here it comes apart in 3D in KitchenAid’s own service order: the end cover and trim band, the pedestal off its hinge pin, the planetary, the gear case’s nine screws, the hub gear and the old grease, then the worm gear in its bracket. Explode spreads the layers; Reassemble puts it back with fresh grease.
A KitchenAid tilt-head stand mixer whose motor hums while the beater stands still. Its head splits into two halves: the gearcase-motor housing, with the motor and the steel worm on its shaft, and the bottom cover, which carries the gears in about 6 fl oz of grease. The fibre worm gear between them is what strips. KitchenAid’s service manual gives this order for the Artisan KSM150 and its tilt-head relatives, the K45SS, KSM75 and KSM90 among them.
Tools: Phillips #2 screwdriver, Flat-blade screwdrivers, one long, 5/32 in drift punch and a pin punch, Hammer with a nylon face, Putty knife